Nada Yoga › Forum › Principale › NadaYoga › How to Build a Wire Fence

xysoom · Registrato: Mag 15, 2020 Messaggi: 1676

How to Build a Wire Fence

When you need a garden fence that’s sturdy and installs quickly, building a wire fence is the best solution. For gardeners, welded-wire mesh fencing will keep out rabbits and dogs, while PVC-coated galvanized wire buried below the ground will keep out woodchucks and moles. A gate at one end or both allows easy access for a wheelbarrow. To get more news about Metal Wire Fence Mesh Acting, you can visit dtwiremesh.com official website.
Installing wire fencing is usually quick and inexpensive work. Wire fence installation is easiest and fastest when using metal fence posts that are driven into the ground. A sturdier version uses regular wood posts set in holes. This guide walks you through how to build a wire fence with wood posts.

Before you learn how to build a wire fence, carefully plan and mark the location of the fence posts and gate. When planning, use a string like mason’s line. Mason’s line is a good choice because it is strong and flexible enough to be pulled tightly. Run the string line to represent either the outside or inside perimeter of the fence.
Lay out the fence perimeter using batter boards and mason’s line, extending the lines several feet at each end so they cross at the corners.
Square the corners using the Pythagorean theorem (3, 4, 5 method). Measure 3-feet from where the lines intersect and make a mark on the string line. Measure 4-feet along the line that runs perpendicular to that line and make a mark. Measure between the 3-feet and 4-feet marks and adjust the line until the marks are exactly 5-feet apart.
Repeat this process to square the remaining corners.
Square can be checked by measuring diagonal lines from opposing corners. If both diagonals have the same measurement, the corners are square.
Use spray paint to mark the location of each corner post.
Measure off the string lines to determine the locations of the field posts 8-feet away from the corner posts and mark the locations just inside the strings.
If installing a gate, mark locations for the gateposts 36-inches apart, allowing for a gate wide enough to accommodate a wheelbarrow.
Call 811 before you dig. Your local utility company will mark the location of any water, gas and power lines in your yard. Avoid digging near any marked lines.
Dig holes using a post hole digger or two-person auger. You can rent an auger and make quick work of digging the post holes. If using an auger, avoid any areas marked by the utility company. To be safe, dig by hand if a hole needs to be located within 18- to 24-inches of a marked utility.
Dig 8-inch diameter holes approximately 1/3 as deep as the posts' height, plus about 6-inches for gravel.
In colder climates, dig below the frost line to avoid heaving. You can look up the frost line in your area online or contact your local building office. Not digging sufficiently below the frost line will cause the posts to heave out of the ground as the temperature changes.